Multi-Channel Analog Output Module e.bloxx D1
The e.bloxx series is designed for industrial and experimental test systems requiring precise high speed measurement of electrical, thermal, and mechanical quantities in engine and component test beds
All units are based on a clean modular design, and easily connect to the wide variety of field devices used in today’s test beds.
Sample rates up to 1000 Hz and resolutions up to 19 bit are possible depending on the module and signal type used.
Standardized communication protocols (Profibus-DP and Modbus-RTU) allow the e.bloxx family to work with a wide variety of application hardware and sofware.
Adding an e.series Test Controller dramatically increases the systems throughput and connectivity options.
An e.series Test Controller is a data concentrator, communication gateway, and optionally a Programmable Automation Controller (PAC) with 100Mbps Ethernet, Profibus-DP, EtherCAT, or CANopen.
Most important features:
◘ 8 or 32 configurable digital inputs / outputs
◘ Status in/outputs
. Process or host controlled
. (each I/O can be configured as IN or OUT)
◘ Frequency in/outputs
. Frequency measurement up to 2 MHz,
. frequency output up to 10 kHz
◘ Counter inputs
. Quadrature counter, up/down counter, up to 400 kHz
◘ PWM in/outputs, time measurement
. Measurement of duty cycle and frequency
◘ Signal conditioning
. Additional scaling, minimum/maximum, arithmetic, alarm
◘ RS 485 fieldbus interface
. Profibus-DP, Modbus-RTU, ASCII
. as well as connectable to any e.series Test Controller
◘ Galvanic isolation
. of I/O-signals, power supply and interface
. Isolation voltage 500 VDC
◘ Electromagnetic Compatibility
. according EN 61000-4 and EN 55011
◘ Power supply 10…30 VDC
◘ DIN rail mounting (EN500022)